KJams Rotory 2

A dual speed rotary simulator! This pedal features true bypass, built-in speed switch, external speed switch input, external expression pedal input, output level control, real wood control panel, and three program control pots. The pedal is based on the Spin FV-1 DSP chip. It is designed and assembled in Holland, Michigan, USA. The Rotary 2 pedal has two PROGRAMS, selectable by the toggle switch: -Single (down) – Rotary with two Speed controls and Horn/Woofer mix control. -Dual (up) – Rotary with two Speed controls, Horn/Woofer mix control, and a second Horn (makes it chorus-y) FOOTSWITCHES -Bypass is a standard bypass/enable latching switch. -Spd1/Spd2 toggles the rotary speed between the settings on the two Speed controls. See below. POTS -Speed controls –The two Speed controls set the maximum and minimum speeds. –Which Speed control is currently active is set by the Spd1/Spd2 switch. –If Speed 1 control is set lower than Speed 2, pressing the Spd1/Spd2 switch will cause the speed to gradually change from one speed setting to the other. –If Speed 1 is set higher than Speed 2, pressing the Spd1/Spd2 switch will cause the speed to immediately change from one speed setting to the other. -Hi/Lo Mix is the mix of the horn and woofer. It acts similar to a tone control. -Volume controls output level. JACKS -In and Out jacks are standard mono, right to left. -Spd1/Spd2 external input functions in parallel with and exactly like the Spd1/Spd2 footswitch. -Expression replaces the middle/lower control, Speed 1. –If the last tap on Spd1/Spd2 has set the pedal to Speed 1 control, the Expression pedal controls the speed. –If the last tap on Spd1/Spd2 has set the pedal to Speed 2 control, the Expression pedal does not control the Speed until Spd1/Spd2 is pushed again.